Shadow of Destiny (USA) m33 fix

[addyaustin]

Warning

The MD5 checksum of your original ISO must match 2588C6ACFEC6B588FCE3C57B8E20C7F1 or this kit/patch will NOT work.
If your ISO is just a few bytes smaller, try re-saving it with UMDGen and if you need a tool to check your MD5, look here

Info
-----
original size
1.02 GB (1,098,246,144 bytes)

ripped size
927 MB (973,023,232 bytes)

CSO & ripped size
650 MB (681,734,400 bytes)

Ripped
-------
Boot.bin
Update

Patched
-------
CFW check removed

patch by - addyaustin (pspripkits.com)

[SpikeXXX]

After I hit start on the main menu I get a screen that says prologue then I'm on a black screen and nothing happens from there. Anyone else getting this problem?

the ripkit itself works fine

[addyaustin]

You need to use sony np9660 driver. M33 driver won't work in this game.

[SpikeXXX]

it worked thanks dude

[lestatu2]

576 full rip (downsampled audio and video)

tomorrow I'll post ripkit...I hope so...

[addyaustin]

That's great!! Did that obscure ripkit worked fine, bro?

[Kre]

Hey guys, I realize it's been a month since someone posted in this topic, but I'm having some trouble and hoped someone could help me out a little. I used the ripkit on my iso, compressed it into a cso, and then put it on my PSP. I hit 'Select' to bring up the little menu, and switch my driver from the M33 to the Sony one that's mentioned above. However, when I start the game, it brings me back to the PSP menu with an error. 'The game could not be started.(80020148)' I'm trying to run it on a PSP-1000 with CFW 5.00 M33-6. If anyone could give me some answers, I'd greatly appreciate it.

[addyaustin]

Did the patch was applied successfully?

That error pops up when running the game on lower than required firmware. But i fixed that in the patch!

Check and re-apply the patch and if it still persists then follow this :-

Code: Select all

http://www.pspmod.com/forums/psp-software-guides/15942-fixed-game-could-not-started-80010002-80020148-a.html


[Kre]

Alright, yeah, it says the ripkit was applied correctly, but I still get the same error. I've followed the directions in the thread you linked as well, but still no luck. Any other ideas? Thanks for the reply by the way.